You do not require a tape measure to install molding. A few of the most successful trim carpenters do not use tapes, opting rather for a more technique that utilizes the corners of the window as reference points to reduce miters. Whatever you need is nail-gun, miter saw and a pencil and it is possible to install trim across doorways or the windows of any house. In the event that you’re just want to provide your house a face-lift or updating for re-sale, the way a room looks can be significantly changed by installing trim.
Set a miter saw at 45 degrees. Place a bit of molding flat on the miter saw table using the slim edge of the molding facing the blade. Cut a miter on the conclusion of the molding.
Hold the molding up to the very top of the window like you had been planning to set it up there. Flush the edge of the molding with all the window jamb. Flush the brief stage of the miter.
Hold the molding from the jamb with one-hand. Reach over and mark the level where the molding is intersected by the corner of the window jamb.
Swing the miter saw blade to another side. Place the molding. To ensure that when you slice the the molding, the mark becomes the brief stage of the miter align the mark together with the blade. Cut the miter.
Place the molding on the window aligning the brief stage of the miters using the corners of the window jamb. Use nails to be shot by the pin nailer to the window jamb throughout the molding. Space the nails one foot apart.
Place another piece of molding and cut a miter. Hold the molding set up on the window, matching the freshcut miter together with the one which you installed.
Reach over and create a mark where the molding is intersected by the corner of the window jamb. Place the molding on the miter noticed. Swing the blade to another side and slice the the molding on the mark, utilizing the mark as the brief point-of the miter.
Place the molding on the wall. Shoot nails to secure it.
Cut the miter to another piece of molding. As you did, place it to the window jamb. Mark reduce the miter and the corner having a pencil. Install it to the window.
Cut the miter to the piece. Hold it in put on on the window. This time it’s going to be on the very top of the two items that are present. Align the brief point-of the miter together with the quick point-of the present miter on the molding currently in spot. Reach over and mark the corner on the present little bit of molding. Cut the miter.
Drop the little bit of molding on the window jamb set up. Nail it to the jamb.