Whether you are speaking about brand-new sheet metal or reclaimed bits, tin is a building material which has shown up over the past few years in a number of formats. It is functional, but the same time, it may be cosmetic. It might be utilized in different ways for interior settings, which allows the tin the very best environment to last decades, providing you with durability in addition to beauty.
Ceiling
Within interior settings, 1 way tin may be used will be on the ground. You will find old fashioned in addition to new versions of stamped tin available in a range of patterns, in addition to some which are painted. You also can use the same sort of tin that’s utilized on farm buildings and country houses for roofs and walls. Even though they may be set up while new and shiny, you may utilize the rusted old pieces as easily to give your house a worn-in appear even when you just moved into the area or built your first house.
Walls
Just as tin may be used on the ground, it may be used on the walls. There are numerous approaches to accomplish this. The material can be set up in any direction, running vertically or horizontally, and you may choose to cover the whole wall. Instead, wainscots are utilized in which the sheet metal covers the bottom half of the wall, then are capped by a flat board of timber, usually reclaimed cedar or pine. You could also select whichever custom pattern you would like, since there are no limits or restrictions.
Backsplash
Although tin isn’t as common as other sheet metals, like copper and stainless steel, for a kitchen backsplash material — since it’ll rust unless it’s covered with a special coat — it is usable. It is more commonly found in vanity like the laundry room having a sinkless vanity, or at entryway settings in which there is a vanity shelf when you walk in the front door. Again, tin may be set up vertically or horizontally, as well as the material is cut down into strips however high or long you require them.
Installation
Installation of tin depends on the sort of tin you have, and whether you desire a detailed, contemporary appearance or a pastoral, old-fashioned appearance. Stamped tin either is glued on a surface or installed with finish nails so no nail heads are visible unless you are performing a very close inspection. Sheet steel tin is nailed or screwed onto its mounting surface using roofing nails or roofing screws. When cutting tin which has a protective layer covering its surface, never to cut the material using a vibrating or oscillating or spinning sword, since the friction from the heat will burn the protective layer across the edges of the cut. This contributes to premature aging. Rather, cut it with tin snips or electric metal shears. If you are working with new material, always follow manufacturer’s instructions for installation. For older material, check the existing screw holes (if available) and use these as a guideline.